Can motorcycle wheel bearings be reused?
The bearings press-fitted into the wheel hub are sometimes knocked out or pulled out at the time of removal, so they must be replaced with new parts when the wheel is reassembled. However, they ordered parts by mistake or thought they had them in stock, but they didn’t. Reuse of bearings is strictly prohibited.
Can you reuse wheel bearing races?
Always replace the races when replacing wheel bearings. You’ve gotten this far and it’s really not that much more work to do. Use a 1/4″ ratchet extension to bang out the old races. Use the old races to bang in the new ones.
How long should motorcycle wheel bearings last?
Motorcycle wheel bearings only require replacement upon failed inspection. They can last 50k miles or more. Their life depends on original build quality, proper shimming, and environmental exposure to heat dust and moisture.
Can I reuse wheel hub?
As long as the hub isn’t tore up, grooved or otherwise damaged you can reuse it.
Can you reuse wheel bearing seal?
To answer your question about replacing vs reusing the seals. Any time you pull the rear bearing, you have to remove the seal to get the bearing out of the hub. That means you run the risk of deforming the seal. When reinstalled, there’s a good chance it won’t “seal” properly against the axle shaft.
Do motorcycle wheel bearings go bad?
Motorcycle wheel bearings are often neglected by bikers. They think little of them until they go bad. Bad bearings can result in a major crash or damaged bike parts. If your bike is older and you fail to regularly lubricate the wheel bearings, you could also be damaging them.
Do you grease motorcycle wheel bearings?
If your bike’s wheel bearings can be greased, get wheel-bearing grease (the type recommended by your motorcycle manufacturer) and new grease seals as needed, before starting the job. However, if the bearings have shields on only one side, and seem a little dry, then it’s a good idea for some grease to be added.
Can you reuse wheel hub bolt?
That is correct. Overtorque or under-torquing your axle nuts can severly shorten the life of the hub assembly. As for the bolts, they aren’t TTY (torque to yield) so they can be reused. Don’t forget the anti-sieze on the contact surface and threads.
Can you reuse axle seals?
They can be re-used as many times as you desire, as long as you are careful when re-installing the shafts. As long as the seals are still flexible, not torn, and the spring hasnt come off they can be re-used indefinitely.