Can I use wd40 on my trumpet valves?

Can I use wd40 on my trumpet valves?

There’s really not a good substitute for valve oil. Valve oil is a water based lubricant, so it won’t hurt your instrument, but using oil or silicone based lubricants, like WD-40 or T-9, can eat away at the nickel in your instrument and cause serious damage.

Why are my valves getting stuck?

Stuck valves are usually caused by a build-up of deposits and/orcorrosion on the valve stem. Because the fit of the stem in theguide is so snug, it doesn’t take much build-up on the valve stemto interfere with free movement of the valve within the guide.

How do you fix a stuck valve?

Hit the valve with a brass hammer, gently, trying to close it — exhaust valves always stick in the open position. This works well, but slowly. It could take days, maybe a week or longer. Keep soaking, tapping, and hitting until the valve breaks loose.

Can I use olive oil on my trumpet valves?

Using WD-40, mineral oil, olive oil, or other oils found in your home are not recommended for oiling trumpet valves. Although it may be tempting to use these since they are typically easily accessible, it is wise to wait until you can buy proper valve oil. These home-remedies can severely damage a brass instrument.

Can you use Vaseline as valve oil?

You may want to first wipe off the valve to remove debris before applying new oil. Do not oil your valves from the bottom caps. Slide grease keeps slides airtight and maintains smooth movement. Vaseline should never be used because it is corrosive to brass.

How do you free a stuck valve?

What makes a trumpet valve stuck?

This usually happens as the valves get stuck midway through pressing or just as they are about to be pressed. Sticking valves will make it difficult to play in addition to ruining your sound. The best way to handle sticky valves is to use a good quality valve oil and keep them lubricated as often as necessary.

Why are my trumpet valves sticking?

The valves are too sticky. This can occur if the oil has caused debris to loosen in the trumpet valve case. It can be fixed by pulling the valve out and thoroughly wiping it with a clean cloth. It may also be helpful to remove the bottom valve cap to clean the valve casing.

How to clean a stuck trumpet valve?

You may have to take it in somewhere. You can prevent sticking by regularly applying valve oil, every once a week or so, wash out the valves. You can do this by filling a tub with warm or hot water. Enough to submerge the trumpet.

How do you clear a block on a trumpet?

If, at this point, the trumpet still does not blow freely, skip ahead to “Clearing a Block.” Insert the 3rd trumpet valve into the casing closest to the bell, rotating it until the horn blows freely regardless of the valve’s up/down position; the valve guides should click the valve into place.

What happens if you put too much oil on a trumpet?

Too much oil on the valve will cause it to be slow and sluggish. Excess oil will also collect dust and grime eventually leading to a dirty trumpet. You don’t need to put the oil in the holes of the valve surface, just the outside. Once the oil is applied, push the valve back down maintaining it’s orientation.

What happens if you put tuning slide grease on trumpet valves?

If you ever accidentally get tuning slide grease or Lanolin on your trumpet valves, or if it mixes with valve oil, you’ll end up with sticky sludge. That defeats the whole purpose of applying valve oil in the first place—getting your valves to move smoothly and quickly.

https://www.youtube.com/watch?v=TOFzKfB7BtU