Should a compressor go before or after overdrive?
By putting the compressor after the overdrive, any top-end transients or low-end boominess gets compressed, giving an even response. With this signal chain, make sure that the overdrive pedal’s output is set to unity gain to keep the compressor from over-squashing.
Should compressor go before or after wah pedal?
In a pedalboard, the compressor unit generally goes after a wah pedal. While it is of course a matter of preference, putting the compressor first will limit the range, function, and dynamics of the wah pedal. The result will be arguably less musical and pleasing overall.
Where should bass compressor in pedal chain?
Most bassists put compressors near the end of their signal chain to wrangle the wide scope of frequency their bass sounds can create, and I know that putting a compressor at the end of the chain is great for streamlining your tone and making it easier for the person running sound.
Should tremolo go before or after delay?
In general, the tremolo should go last in all the modulation effects, after chorus, phaser, or flanger. By placing the tremolo before both the delay and reverb pedal, it will only affect the dry part of your sound, leaving the delay and reverb to sound even wilder.
Where does the preamp go in pedal chain?
A preamp pedal should be placed quite early in your overall signal chain, and obviously before power amp or cab simulator pedals. As it’s a substitute for an amp’s preamp, it should therefore be one of the first stompboxes that your guitar’s output signal comes into contact with.
Should a compressor come before fuzz?
A good rule of thumb is to place any gain-type effects before modulation effects: i.e., compressors and overdrives before delays or flangers. Another one that’s practically set in concrete is to put the compressor before any overdrive, distortion, or fuzz pedal.
What order should bass pedals be in?
Conventional wisdom suggests that the ideal pedal order is wah/filter, compression, overdrive, modulation and pitch-based effects, delay, and reverb.
Where does Looper go in pedal chain?
Normally, you’ll want the looper to be able to record and playback any of your sounds. Of course, this means you should place it at the very end of the chain so it can hear and record whatever pedal combinations you use.
What order should my pedals go in?