Can you run power from one outlet to another?
Answer: Absolutely you can. Using 12-3 wire (for a 20 amp circuit, or 14-3 wire for a 15 amp circuit) splice the new wire to both wires on the “hot” side of the outlet and to the white wire. You may need to cut 6″ pieces of wire to go from each wire nut to the outlet. Splice the ground to the existing ground as well.
Can lights and outlets be on the same circuit in a bathroom?
No lighting outlets or other equipment can be fed from the same circuit feeding the bathroom receptacles. For example, a one-family dwelling has two bathrooms and a duplex receptacle has been installed in each. One 20-ampere branch circuit can supply power to both bathroom receptacles but cannot feed anything else.
Do lights and outlets need to be on separate circuits?
Generally a properly wired home should have dedicated lighting circuits that are apart from receptacles. Overloaded neutrals are fire hazards.
How far should an electrical outlet be from the wall?
The NEC basically states that within any living area of a home, you must have an electrical receptacle (outlet) 6 feet from any obstruction or break in the wall, such as a doorway, and no more than 12 feet from the previous electrical receptacle (outlet), Figure 1. Figure 1 – Spacing of electrical outlets along a wall
What size circuit do I need for a bathroom outlet?
Depending on the amperage draw of the unit, it’s possible this fixture will require a dedicated circuit of its own. The minimum requirement for outlet receptacles in a bathroom is one GFCI-protected receptacle served by a 20-amp circuit.
Where should an electrical receptacle outlet be located?
The United States National Electrical Code, Section 210.52, states that a receptacle outlet must be placed in every kitchen, bedroom, living room, family room and any other area designated has habitable space. No point, measured along the floor line, can exceed 6 feet from an electrical outlet to reduce the need for hazardous extension cords.
Can you put a line on the wall in a bathroom?
Lines create patterns that can either enhance or detract from the bathroom’s appearance. Too many tiles can make a room feel busy, ponderous, sterile, and even depressing. Partially tiling the wall is a good compromise. Ceramic tile used as wainscot usually stops at a certain point on the wall, around 36 to 38 inches.