Table of Contents
Why is my aquaguard showing red light?
The light is a reminder to change the filter, it does not sense if the filter has been changed or not. When the red light is blinking, press and hold both up and down arrows until the red light blinks RAPIDLY, release both for a second or two, and press and hold both again until it stops blinking.
What does blue light in aquaguard mean?
Mineral Guard™ Micro-controller-based Electronic Impulse Producer Tank Filling LED will blink blue at 0.5 sec rate Input Water Quality Usage Limitations: 1. If the input water iron content is more than 0.3 mg/ltr., use of iron remover* is recommended as a pre-treatment.
Why does aquaguard yellow light blink?
In case of low voltage, the yellow LED will blink and you’ll hear a beeping sound. Switch off the unit till the voltage comes back to normal.
Why does aquaguard green light blink?
Why Green light blinking in Aquaguard Magna HD RO+UV Water Purifier. if you notice the light is continuously blinking means you have to understand that the filters in your purifiers are blocked due to mud or dirty particles in purifier. so the water taste will change.
How do you reset Aqua Guard?
Its a float in one of your unit drain pans. It will only shut your unit down if the water is getting ready to overflow. To “reset it” you just tap it and make sure the float is at the bottom of the switch.
What to do if aquaguard is not working?
Loose connections can also be one of the reasons for your RO water purifier to stop working. If you are satisfied there are no loose external connections, you should contact your AMC provider or the authorised service centre. There could be issues with the input power supply inside the machine.
Why my AquaGuard is not working?
Why my aquaguard is not working?
Can water purifier be switched off?
While most water purifiers can be switched off, it depends on the type of water purifier. Distillation, Reverse Osmosis, Ultrafiltration, and Ultra Violet water purifiers can all be switched off.