How do you draw a rhombus of side 6cm and one angle is 60?

How do you draw a rhombus of side 6cm and one angle is 60?

Step – 2) At A, draw a line AQ so that angle (BAQ) = 60°. Step – 3) Cut AD at C such that AC = 6cm. Step – 4) At B, draw a BP so that angle (ABP) = 180° – 60° i.e. 120°. Step – 5) Cut BP at D such that BD = 6cm.

How do you construct a rhombus with a side and diagonal?

Construct a rhombus given one side and one diagonal

1. Draw line segment AB = 5.4 cm .
2. With B as the centre and radius equal to 5.4 cm , draw an arc.
3. With A as the centre and radius equal to 7.4 cm, draw another arc such that it intersects the previous arc at C.
4. Join points B,C and points A, C.

How do you construct a rhombus with one side and one diagonal?

How do you make a rhombus?

Since the side of the rhombus is 6 cm and one angle = 60 deg, it can be constructed easily . Actually two equilateral triangles on the same base will result in the rhombus. Draw a line AC, 6 cm long. With A as centre and a radius of 6 cm draw arcs above and below the line AC.

How many diagonals does a rhombus have?

In this article, we will discuss a steps to construct rhombus, where the measurement of its two diagonals is given. A rhombus is a quadrilateral with sides of equal length. Opposite sides are parallel and opposite vertex angles are equal.

How to draw rhombus with equilateral triangles?

Actually two equilateral triangles on the same base will result in the rhombus. Draw a line AC, 6 cm long. With A as centre and a radius of 6 cm draw arcs above and below the line AC. With C as centre and the same radius of 6 cm draw arcs above and below the line AC to cut the arcs drawn earlier.

How to draw rhombus in AutoCAD?

Hence, we do not require any other dimension for the construction of rhombus. The steps are: Draw a vertical line segment PR of length 6 cm. Take the compass of any radius and from the point P, mark an arc towards the left and the other towards the right of PR.